We got a T1 200 which pops it fuse in the power cable when the
buildings power goes.

I had this problem before, reset alarm 3 and try it. Thats what worked
for us each time.

michaeldale@gmail.com wrote:
> I just picked up a Sun Netra T1 200.
>
> It seems to have some hardware problem. When you plug it in the repair
> light flashes 3 times and then nothing happens. Pressing the power
> button does not start the system.
>
> I can access LOMlite and here is what it outputs
>
> LOMlite starting up.
>
> CPU type: H8/3437S, mode 3
> Ram-test: 2048 bytes OK
> Initialising i2c bus: OK
> Searching for EEPROMs: 50(cfg)
> I2c eeprom @50: OK
> i2c bus speed code 01... OK
> Probing for lm80s: 28
> Initialising lm80 @28: OK
> Probing for lm75s: none
> System functions: PSUs fans breakers rails gpio temps host CLI ebus
> clock
> Power restored
>
> lom>environment
> Fault OFF
> Alarm1 OFF
> Alarm2 OFF
> Alarm3 ON
>
> Fans:
> 1 fan1 OK standby
> 2 fan2 OK standby
> 3 cpu OK standby
> 4 psu OK standby
>
> PSUs:
> 1 OK standby
>
> Temperature sensors:
> 1 Enclosure 29degC OK
>
> Overheat sensors:
> 1 CPU standby
>
> Circuit breakers:
> 1 SCSI-Term standby
> 2 USB0 standby
> 3 USB1 standby
> 4 SCC standby
>
> Supply rails:
> 1 5V standby
> 2 3V3 standby
> 3 +12V standby
> 4 -12V standby
> 5 CPU core standby
> 6 +3VSB standby
>
> lom>show
> escape #.
> model Netra T1 200
> hostname netscreen.global.provisioner
> power-on-decline off
> power-on-delay off
> ip-address not set
> ip-netmask not set
> ip-gateway not set
> bootmode normal
> rsc-security on
> event-reporting on
> Time since last boot: +0h2m36s
>
> If I type poweron nothing happens. Any ideas?
>
> Thanks!