On Sun, 17 Oct 2004 12:44:11 +0100, "David Coles"
<david.coles5@ntlworld.com> wrote:

>I am rebuilding a B2000 from an ignite boot image and on boot up, the system
>does not recognise that it has a hard disk installed. I have tried the disk
>in both the SCSI 6 and SCSI 5 positions. The disk is spinning in both slots.
>
>The unit does recognise the CD-ROM drive and an externally connected DAT
>tape drive. I enclose the output from the system below. Any help you could
>give would be most appreciated

Is the SCSI bus terminated?