The kernel reports following:

kernel: VIA VT6105 Rhine-III at address 1, status 0x786d advertising 05e1
Link 45e1
kernel: Setting full-duplex based on MII #1 link partner capability of 45e1.

How does this sound like? I wonder if full-duplex is good since some guys
have had problems with it. I didnt install the drivers from the CD since I
heard they are bad, but went with the ones my 2.4 Linux offered

I had one connection breakout but it was fixed when I restarted eth0. So far
it has been running OK.

"Mr.Jason" <jaakkochanREMOVETHIS@surfeu.fi> wrote in message
news:429b2356$0$7610$f4da826c@news.24online.fi...
> Okay fellows, before I start a new thread therefore I announce that I have
> learned my lesson and wont top-post again. Sorry for the bother.
>
> I finally got myself a new nic, didn't installed it yet though. It is:
> D-Link DFE-530TX
>
> Anyone got experiences of this? Any recommendations for installation
> procedure?
> I hope its better than my poor RTL baby.
> Mr.Jason
> -----
> Check out the New Album
> http://cutout.ath.cx
> Listen my music at
> http://www.rocketradio.com/mrjason
> Get my previous CD East End
> http://www.cdbaby.com/mrjason
>