Bridge_Xue%yahoo.com wrote:
|
| I am using a SPARC 20 workstation to tip hardwire to an Ultra 2 box.
| When enter "tip hardwire" there is "connected" showup, not thing else.
|
| The tip hard wire cable, /etc/remote file all correct. The only thing
| is the SPARC 20 Workstation only has one serial port.


You have correctly observed that the Sparcstation 20 has only
one serial DB-25 *connector*. But that single connector
implements 2 serial *ports*, on different pins.


You should read some of the information here:

http://www.stokely.com/unix.serial.p...blepinout.html
http://wwwnlds.physik.tu-berlin.de/~.../hardware.html


| Could some one help with trouble shoot tip hardwire? The baud rate is
| set to 9600 on the Sparc 20. I am not sure if I need to do something
| in regards to ttymon or sacadm. Please advise!


You should read some of the information available here:

http://www.stokely.com/unix.serial.p...ces/index.html

--
Helpful Observer